Carbon Tank Soak - Pentair PC1665-P Quick Start Manual

CARBON TANK SOAK

Note: Your system will not be ready for use for a minimum of 48 hours while the Carbon Soak process takes place.
Please plan your installation accordingly.
Notice
Water will flow out of the filter head during this process. Be sure you perform this series of steps in a location suitable for
water flow.
Top View
Garden
Hose
Carbon Tank Soak
Note: Steps 1-8 should be done prior to installation
1. Connect the 1-½" threaded PVC adapter to the inlet side of the tank head.
2. Connect the 1" threaded PVC adapter into the 1-½" adapter.
3. Connect the ¾" PVC hose bib into the 1" adapter.
4. Connect your garden hose to the Hose bib adapter.
5. Repeat steps 1-4 on the Outlet side of the tank head.
6. Fill the Pentair Carbon Water Filter System tank full until water flows out of the second hose.
7. Turn the water off.
8. Allow the carbon tank to soak for at least 48 hours prior to tank installation.
INLET OUTLET
Garden
Hose
Water Filter
1½˝ to 1˝ Threaded 1˝ to ¾˝ Threaded
PVC Adapter PVC Adaptor
To filter
head
¾˝ PVC
Hose Bib
Water
HIGH FLOW WHOLE HOUSE WATER FILTER • 5
Garden
Hose