Delphi SkyFi SA10000 Installation Manual page 19

2. Begin routing the wiring from the
antenna toward the receiver.
3. Work the antenna cable under the rear-
window molding. Heating the molding
may help if it is hard.
4. Make adjustments and take up slack
where necessary. If additional cable
length is needed, purchase a TERK
15-foot cable extension kit (TERK model #
TRK-SREXT).
5. When you reach the SKYFi Car Cradle,
verify that the connector is clear of
obstruction, and that the cable is not
kinked, crimped, or chafed. Reconnect
the antenna and receiver leads. (If you
have removed the antenna connector,
reconnect this first.)
6. Slide the SKYFi Receiver into the car cra-
dle until you feel the connector click.
Push down on the locking tab in back in
order to firmly lock your SKYFi in place
while driving.
® XM
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
Changes or modifications not expressly
approved by Delphi could void the user's
authority to operate this equipment.
18