Table of Contents
Advertisement
Fault
The appliance is not working.
"Sprache Deutsch" appears in
the display.
The operation does not start or is
interrupted.
Appliance does not heat up.
The time is not displayed when
the appliance is switched off.
The control ring has fallen out of
the mount in the control panel.
The control ring is difficult to turn. There is dirt below the control ring.
The interior lighting does not
work.
Maximum operating time
reached.
Cause and troubleshooting
There has been a power cut.
Check whether the lighting in your kitchen or other appliances are working.
▶
There has been a power cut.
Implement the settings for the initial configuration.
▶
– Language
– Clock
Different causes are possible.
Check any notifications that appear in the display.
▶
→ "Displaying information", Page 11
Malfunction
Call the after-sales service.
▶
→ "Customer Service", Page 23
Demo mode is activated in the basic settings;
Briefly disconnect the appliance from the power supply by switching the cir-
1.
cuit breaker in the fuse box off and back on again.
Deactivate demo mode within three minutes in the
2.
→ "Basic settings", Page 14.
There has been a power cut.
Open and close the appliance door once after a power failure.
▶
a The appliance is checked and is ready to use.
Basic setting has been changed.
Change the basic setting for the time display.
▶
→ "Basic settings", Page 14
The control ring has been detached.
Insert the control ring into the mount in the control panel.
1.
Push the control ring into the mount so that it clicks into place and can be
2.
turned.
The control ring can be removed.
Note: To ensure that the mount remains stable, do not remove the control ring
too often.
To loosen the control ring, press on the outer edge of the control ring.
1.
a The control ring tilts and is easier to grip.
Remove the control ring from the mount.
2.
Clean the control ring and its mount on the appliance carefully using soapy
3.
water and a dish cloth. Dry with a soft cloth.
Do not use any harsh or abrasive cleaning agents.
Do not soak the control ring.
Do not clean the control ring in the dishwasher.
The halogen lamp is defective.
Change the oven light bulb.
▶
→ "Replacing the oven light bulb", Page 22
To prevent an unwanted permanent operation, the appliance automatically stops
heating after several hours if the settings are unchanged. A message appears in
the display.
The point at which the maximum operating time is reached is determined by the
corresponding settings for an operating mode.
To continue the operation, press any touch field and turn the control ring.
1.
If you do not need to use the appliance, use
2.
Tip: To prevent the appliance from switching off when you do not want it to, set
a cooking time.
→ "Setting the cooking time", Page 12
Troubleshooting en
appears in the display.
to switch it off.
21
Advertisement
Table of Contents
