Table of Contents
Advertisement
5 Operation
Indoor unit quiet operation. When the airflow rate is
set to "
", the noise from the unit will be reduced.
INFORMATION
▪ If the unit reaches the temperature setpoint in cooling
or heating mode, the fan will stop operating.
▪ When using drying operation mode, you CANNOT
adjust the airflow rate setting.
To adjust the airflow rate
1 Press
to change the airflow setting as follows:
5.3.3
Airflow direction
When. Adjust the airflow direction as desired.
What. The system directs the airflow differently, depending on the
user selection (swinging or fixed position). It does so by moving the
vertical blades.
Setting
Moves up and down.
Vertical auto swing
[—]
Stays in a fixed position.
CAUTION
▪ ALWAYS use a user interface to adjust the angle of the
flap. When the flap is swinging and you move it forcibly
by hand, the mechanism will break.
▪ Be careful when adjusting the louvers. Inside the air
outlet, a fan is rotating at high speed.
Note: The movable range of the flap varies according to the
operation mode. The flap will stop at the upper position when the
airflow rate is changed to low during the up and down swing setting.
a
b
c
a
Flap range in cooling or drying operation
b
Flap range in hating operation
c
Flap range in fan only operation
To adjust the airflow direction
1 To use auto swing, press
Result:
will appear on the LCD.
Result: The flap (horizontal blade) will begin to swing.
2 To use fixed position, press
desired position.
Result:
disappears from the LCD.
To adjust the louvers (vertical blades)
1 Hold 1 or both knobs and move the louvers.
Operation manual
8
Airflow direction
.
when the flap reaches the
a
a
Knobs
INFORMATION
When the unit is installed in a corner of a room, the
direction of the louvers should be facing away from the
wall. Efficiency will drop if a wall blocks the air.
5.3.4
Comfort airflow operation
This operation can be used in heating or cooling operation mode. It
will provide a comfortable wind that will NOT come in direct contact
with people. The system automatically sets the fixed airflow position
upward in Cooling and downward in Heating operation mode.
Cooling operation mode
INFORMATION
Powerful and Comfort airflow operation CANNOT be used
at the same time. The last selected function takes priority.
If the vertical automatic swing is selected, Comfort airflow
operation will be cancelled.
To start/stop Comfort airflow operation
1 Press
to start.
Result: The flap position will change,
LCD, and the airflow rate is set to automatic.
Mode
Cooling/Drying
Heating
2 Press
to stop.
Result: The flap will return to the position from before the Comfort
airflow mode;
disappears from the LCD.
5.3.5
Powerful operation
This operation quickly maximizes the cooling/heating effect in any
operation mode. You can get the maximum capacity.
INFORMATION
Powerful operation CANNOT be used together with Econo
and Comfort airflow operation. The last selected function
takes priority.
Powerful operation will NOT increase the capacity of the
unit if it already operates at maximum capacity.
To start/stop Powerful operation
1 Press
to start.
a
Heating operation mode
is displayed on the
Position of flap...
Up
Down
CTXF20~35C5V1B
Daikin room air conditioners
3P520336-11K – 2020.08
Advertisement
Table of Contents
