Storage; Storage Safety; Preparing The Machine For Storage - Toro Groundsmaster 3500-D Operator's Manual

7. Tighten the blade bolt to 115 to 149 N∙m (85 to
110 ft-lb).
Checking the Blade Stopping Time
Service Interval: Before each use or daily
The cutting unit blades should stop within 7 seconds
after you shut off the cutting units.
Note:
Ensure that the cutting units are lowered onto
a clean section of turf or hard surface to avoid thrown
dust and debris.
To verify the stopping time, have an assistant stand
at least 6 m (20 ft) away from the cutting unit and
watch the blades on 1 of the cutting units. Shut off
the cutting units and record the time that it takes for
the blades to come to a complete stop. If the time
is longer than 7 seconds, the braking valve needs
adjustment; contact your authorized Toro distributor
for assistance in making this adjustment.

Storage

Storage Safety

•
Shut off the engine, remove the key, and wait
for all movement to stop before you leave the
operator's position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or other appliance.
Preparing the Machine for
Storage
Important:
Do not use brackish or reclaimed
water to clean the machine.
Preparing the Traction Unit
1. Thoroughly clean the traction unit, cutting units,
and engine.
2. Check the tire pressure; refer to
Tire Pressure (page
3. Check all fasteners for looseness and tighten
them as necessary.
4. Grease all grease fittings and pivot points. Wipe
up any excess lubricant.
5. Lightly sand and use touch-up paint on painted
areas that are scratched, chipped, or rusted.
Repair any dents in the metal body.
6. Service the battery and cables as follows:
A. Remove the battery terminals from the
battery posts.
Note:
Always disconnect the negative
terminal first and the positive last. Always
connect the positive terminal first and the
negative last.
B. Clean the battery, terminals, and posts with
a wire brush and baking soda solution.
C. Coat the cable terminals and battery posts
with Grafo 112X skin-over grease (Part
Number 505-47) or petroleum jelly to
prevent corrosion.
D. Slowly recharge the battery every 60 days
for 24 hours to prevent lead sulfation of the
battery.
Preparing the Engine
1. Drain the engine oil from the oil pan and replace
the drain plug.
61
Checking the
48).