Route The Cable - Precor Resolute RSL 620 Assembly Manual

Route the Cable

Image
1
2
3
4
43
56
1
©2019 Precor Inc. | Inner Thigh RSL 620 | Assembly Guide
Hardware
Tools: Hex wrench, 8 mm
Hex wrench, 4 mm
Tools: Hex wrench, 8 mm
Open-end wrench, 19 mm
Torque wrench
43
4 M10 x 25 mm SHCS
8
56
4 washers, 11 mm, black
Tools: Hex wrench, 8 mm
Torque wrench
Instructions
Route cable through pulley on lower cross brace. Slide cable through cable
retainer and around pulley groove.
To route the cable around the lower pulley on the weight stack tower, remove
the cable retainer. Route the cable around the pulley and then replace the
cable retainer.
To route the cable to the upper pulleys of weight stack tower, remove the cable
retainers, route the cables, and replace the retainers. Tighten to 50 ft-lb (67
N-m) of torque.
8
Mount foot plate to lower cross brace
torque.
1
. Tighten to 42 ft-lb (57 N-m) of
10