Installation Of The Lan Board(For Setting Pc)(For Settings Pc); The Tcp/Ip Protocol Settings (For Settings Pc)(For Settings Pc) - Buffalo AirStation WLAR-L11-L Internet Connection Manual

Install the following into the setting PC for setting the AirStation.
• LAN Board Driver............................................ Refer to the following "Installation of LAN Board (to the
• AirStation Manager ................................................... Refer to the "Installing the AirStation Manager" section (page
• TCP/IP Protocol.........................................................."The TCP/IP Protocol Settings (for setting PC)" section (page 9)
• Web Browser (Internet Explorer 4.0 or later,
or Netscape Navigator 3.0 or later)...................................Refer to the relevant Web browser manual. Microsoft Internet
Installation of the LAN Board (for setting PC)
Refer to the LAN board manual for the installation.
When using the WLI-ISA-OP or WLI-PCI-OP
Before installing the Wireless LAN Card (WLI-PCM-L11 etc.), install the WLI-ISA-OP or WLI-PCI-OP
(hereinafter called the Adapter) and the bus adapter driver. Refer to the attached Bus Adapter Manual
for the installation procedure.When using the WLI-PCI-OP Adapter, a WLI-PCI Driver Disk is required.
The TCP/IP Protocol Settings (for setting PC)
Set a tentative IP address for the AirStation setting.
Set the IP address according to the following procedure.
The TCP/IP Protocol Setting(Windows Me/98/95)
The TCP/IP protocol is set as follows.
1
Start your PC.
2
Click the Start button, and then select Settings, and Control Panel.
3
Double-click the Network icon.
4
In the Network dialog box, verify that the TCP/IP is displayed in "The following
network components are installed" field.
Only 1 LAN board installed
If TCP/IP is not displayed, refer to the "Adding the TCP/IP Protocol (Windows Me/
98/95)" section (page 11) and add the Internet protocol (TCP/IP).
setting PC)."
12).
Explorer is installed as standard on Windows Me/98.
The dial-up adapter and the LAN
boards are installed.
TCP/IP (LAN board driver name) is normally
displayed in "The following network compo-
nents are installed:" field.
WLAR-L11-L Internet Connections Manual
Continue to next page
9