Buffalo AirStation WLA-G54 Quick Setup Manual page 11

Connect the AirStation
to your existing LAN
Once Configuration is complete, plug the provided 7ft. Ethernet cable into one of
the 10/100M Ethernet ports on the AirStation 54Mbps Bridge and plug the other
end into an Ethernet hub or switch on your Local Area Network.
If at any time you wish to restore settings to factory defaults, press the red INIT button
on the rear of the AirStation for several seconds until the red DIAG light illuminates.
Configure your TCP/IP Settings to match LAN settings
Once the AirStation is connected to the existing LAN, users accessing the
LAN through the AirStation must configure the Network Settings (OSX) and
TCP/IP Settings (OS9) to match your existing LAN.
Contact your network administrator if your computer requires a static IP
Address or if using DHCP Services.
Apple, Macintosh and the Apple logo are trademarks of Apple Computer Inc.
For more information regarding Apple Products, visit
http://www.apple.com
11