Page 63
Dell Computer Corporation (www.dell.com) Precision WorkStation 210 M Setup Device List Boot Device Priority: Diskette drive A Hard drive C: CD-ROM device Exclude from Boot Device Priority: Device Controller Priority: System BIOS boot devices Ctrl-Del original list Ctrl move item...
Page 71
Type in the password and... — press <ENTER> to leave password security enabled. — press <CTRL><ENTER> to disable password security. Enter password: Type the password and press <Enter>. ** Incorrect password. ** Enter password:...
Page 72
** Incorrect password. ** Number of unsuccessful password attempts: 3 System halted! Must power down.
Page 133
Time-of-day not set — please run SETUP program Invalid configuration information — please run SETUP program Strike the F1 key to continue, F2 to run the setup utility...
Page 182
Out of memory Memory allocation failed Not enough memory to run the ICU Can’t open index file. This file is required for ICU to run. No Configuration Manager. device= drivers\dos\dwcfgmg.sys c:\plugplay...
Page 183
At least one Plug and Play card in your system is not configured due to conflicts. These are marked “config err” in the list of configured cards. Due to conflicts, the ICU could only configure some Plug and Play cards in your system.
Page 184
The loaded card is not a category card. Press OK to proceed. No more DMA values can be added. No more interrupt values can be added. No more memory values can be added. No more I/O port values can be added.
Page 185
The ICU detects a resource conflict between this card and conflicting_card. The conflicting resource was: resource. resource conflicting_card conflicting_card conflicting_card...
Page 186
The configuration (.cfg) file used by the ICU for this card is now invalid or does not exist. Do you wish to load the file? No configuration (.cfg) file exists for the card being modified. Do you want to load one? This is an EISA system.
Page 187
Found Plug and Play ISA card: Plug and Play ISA Card Name . NOTICE: Boot Device Not Active! CSN= Card Select Number . One or more active devices have been reconfigured -- system requires reboot. Press any key to reboot system. The Plug and Play ISA card has been successfully...
Page 188
ERROR: Could not read NVS, Error=Internal Error Code. ERROR: Failed NVS write. Error=Internal Error Code. ERROR: Failed to activate device, CSN=Card Select Number.
Page 189
WARNING: Could not configure Plug and Play Card Name. WARNING: Could not configure PCI device, ID=DeviceID. Failed to configure Number of Total Count Plug and Play ISA devices. Use your system’s configuration utility to resolve conflicts. Press any key to config err continue.
Page 190
WARNING: Could not configure Plug and Play Card Name. WARNING: Could not configure PCI device, ID=DeviceID. Failed to configure Number of Total Count Plug and Play ISA devices. Use your system’s configuration utility to resolve conflicts. Press any key to continue.