Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for DeWalt XR DCE800
Summary of Contents for DeWalt XR DCE800
- Page 1 DCE800 Final page size: A5 (148mm x 210mm)
- Page 2 English (original instructions) Copyright D WALT...
- Page 3 Fig. A Fig. B XXXX XX XX...
- Page 4 Fig. C Fig. D Fig. E Fig. F Fig. G Fig. H...
- Page 5 Fig. I...
-
Page 6: Technical Data
English DRYWALL SANDER DCE800 Congratulations! EC-Declaration of Conformity You have chosen a D WALT tool. Years of experience, thorough Machinery Directive product development and innovation make D WALT one of the most reliable partners for professional power tool users. Technical Data Drywall Sander DCE800 DCE800... -
Page 7: General Power Tool Safety Warnings
*Date code 201811475B or later **Date code 201536 or later English Batteries Chargers/Charge Times (Minutes) Weight (kg) DCB104 DCB107 DCB112 DCB113 DCB115 DCB118 DCB132 DCB119 Cat # DCB546 18/54 6.0/2.0 1.05 DCB547 18/54 9.0/3.0 1.46 135* 135* DCB548 18/54 12.0/4.0 1.44 DCB181 0.35... -
Page 8: Additional Specific Safety Rules
English h ) Do not let familiarity gained from frequent use of contacts eyes, additionally seek medical help. Liquid tools allow you to become complacent and ignore ejected from the battery may cause irritation or burns. tool safety principles. A careless action can cause severe e ) Do not use a battery pack or tool that is damaged or injury within a fraction of a second. -
Page 9: Kickback And Related Warnings
English run out of balance, vibrate excessively and may cause loss in turn causes the uncontrolled power tool to be forced in the of control. direction opposite of the accessory’s rotation at the point of the binding. g ) Do not use a damaged accessory. Before each use inspect the accessory such as abrasive wheel for For example, if an abrasive wheel is snagged or pinched by the chips and cracks, backing pad for cracks, tear or... -
Page 10: Residual Risks
English WARNING: Do not use the dust filter cassette or the dust Using an Extension Cable extraction adaptor to store objects. An extension cord should not be used unless absolutely necessary. Use an approved extension cable suitable for Sanding Paint the power input of your charger (see Technical Data). The WARNING: Observe the applicable regulations for minimum conductor size is 1 mm ;... -
Page 11: Wall Mounting
English If the charger indicates a problem, take the charger and battery charger is ventilated through slots in the top and the bottom of the housing. pack to be tested at an authorised service centre. • Do not operate charger with damaged cord or plug— hot/Cold Pack Delay have them replaced immediately. - Page 12 English READ ALL INSTRUCTIONS terminals are protected and well insulated from materials that could contact them and cause a short • Do not charge or use battery in explosive atmospheres, circuit. NOTE: Lithium-ion batteries should not be put in such as in the presence of flammable liquids, gases or checked baggage.
-
Page 13: Package Contents
English batteries of 36 Wh each. The Use Wh rating might indicate Battery Type 108 Wh (1 battery implied). The following SKU(s) operate on a 18 volt battery pack: DCE800 Storage Recommendations These battery packs may be used: DCB181, DCB182, DCB183, DCB183B, DCB184, DCB184B, DCB185, DCB187, DCB189, 1. -
Page 14: Assembly And Adjustments
English Attaching Sanding Discs (Fig. C) Tube expansion lever Sanding pad Your DCE800 drywall sander is designed to use 225 mm sanding Intended Use discs 11 . Sanding discs for the DCE800 attach with hook and loop. This drywall sander is designed for professional The recommended sanding discs are available at extra cost from sanding applications. -
Page 15: Operation
English Brush-Type Skirt (Fig. C) installing attachments or accessories. An accidental start-up can cause injury. A brush-type skirt surrounds the abrasive pad on the 12 Proper Hand Position (Fig. I) DCE800. This skirt serves two purposes: • It extends below the surface of the abrasive pad to prevent WARNING: To reduce the risk of serious personal injury, the abrasive from “gouging”... -
Page 16: Maintenance
English NO EATING, DRINKING or SMOKING should be done in Use a cloth dampened only with water and mild soap. the work area to prevent ingesting contaminated paint Never let any liquid get inside the tool; never immerse any particles. Workers should wash and clean up BEFORE part of the tool into a liquid. - Page 20 Belgique et WALT - Belgium BVBA Tel: NL 32 15 47 37 63 www.dewalt.be luxembourg België en luxemburg Egide Walschaertsstraat 16 Tel: FR 32 15 47 37 64 enduser.BE@SBDinc.com 2800 Mechelen Fax: 32 15 47 37 99 Danmark WALT (Stanley Black&Decker AS)