Cisco Nexus 93108TC-FX3P Hardware Installation Manual page 27

Installing the Chassis
c) Secure the front-mount bracket to the chassis using four M4 screws and tighten each screw to 12 in-lb (1.36 N·m)
of torque.
d) Repeat Step 1 for the other front rack-mount bracket on the other side of the switch and be sure to position that bracket
the same distance from the front of the switch.
Step 2 If you are not installing the chassis into a grounded rack, you must attach a customer-supplied grounding wire to the
chassis as explained in the
rack, you can skip this step.
Step 3 Insert the switch into the rack and attach it as follows:
a) Holding the switch with both hands, position the brackets on the switch between the cabinet posts (see the following
figure).
Installing the Switch into a Two-Post Rack Using the NXK-ACC-KIT-1RU Rack-Mount Kit
Grounding the Chassis, on page 21
Cisco Nexus 93108TC-FX3P NX-OS Mode Switch Hardware Installation Guide
section. If you are installing the chassis into a grounded
19