Rohs (Restriction Of Hazardous Substances); Manufacturer's Warranty - Hilti TE 500-A36 Original Operating Instructions

Trouble or fault
1 LED on the battery flashes.
4 LEDs on the battery flash.
Product does not develop full
power.
The insert tool cannot be re-
leased from the chuck.
Product does not start.
The service indicator lights.
The service indicator blinks.
The ON/OFF indicator
flashes.
10 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11

RoHS (Restriction of Hazardous Substances)

Click on the link to go to the table of hazardous substances: qr.hilti.com/r10130182.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
12

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
*2240495*
Printed: 16.07.2019 | Doc-Nr: PUB / 5503655 / 000 / 00
Possible cause
The battery is discharged.
The battery is too hot or too cold.
Product momentarily overloaded.
Protection against overheating.
The control switch is not fully
pressed.
The half-power button is engaged.
The chuck is not pulled back fully.
The side handle is not fitted cor-
rectly.
The electronic restart interlock is
activated after an interruption in
the electric supply.
Service limit time reached.
The product is faulty.
Product momentarily overloaded.
Protection against overheating.
2240495
Action to be taken
▶ Change the battery and charge
the empty battery.
▶ Bring the battery to the recom-
mended working temperature.
▶ Release the control switch and
then press it again.
▶ Allow the product to cool down
and clean the air vents.
▶ Press the control switch as far
as it will go.
▶ Press the "half-power" button.
▶ Pull the chuck back as far
as it will go and remove the
accessory tool.
▶ Disengage the side handle and
refit it correctly so that the
clamping band and side handle
engage in the recess.
▶ Switch the product off and then
on again.
▶ Have the product repaired by
Hilti Service.
▶ Have the product repaired by
Hilti Service.
▶ Release the control switch and
then press it again.
▶ Allow the product to cool down
and clean the air vents.
English 23