Operating the appliance
en
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
Touch the Start/Reload A button.
1.
Select another programme.
2.
And touch the Start/Reload A
3.
button again. The new programme
starts from the beginning.
Cancel the programme
For programmes at high temperatures:
Touch the Start/Reload A button.
1.
To cool down laundry: Select à
2.
Rinse.
And touch the Start/Reload A
3.
button again.
For programmes at low temperatures:
Touch the Start/Reload A button.
1.
Select 0 [ Spin/Drain.
2.
And touch the Start/Reload A
3.
button again.
Programme end
End lights up on the display panel and
~ and Õ displays are off.
If you have selected 2, the water is only
drained after rinse process, no spin
cycle.
34
Removing laundry/switching
off the appliance
Set programme selector to Off.
1.
Open the door and remove the
2.
laundry.
Turn off the water tap.
3.
Not required for Aqua-Stop
Note:
models.
Notes
Do not leave any items of laundry in
■
the drum. They may shrink in the
next wash or discolour another item.
Remove any foreign objects from the
■
drum and the rubber seal – risk of
rusting.
Wipe the rubber seal dry.
■
Leave the door and detergent
■
drawer open so that any residual
water can evaporate.
Always wait until the programme
■
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for it to unlock.