Gigabyte Z490 UD AC User Manual page 15

_
B
S B_
B
S B_
B
_ S
7) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors)
S_
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
_
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel
B
RAID 1, RAID 5, and RAID 10. Refer to Chapter 3, "Configuring a RAID Set," for instructions on configuring
_ S
a RAID array.
_ U
S_
_
_
B
B
SB3 F
_ U
_
B
SB3 F
S _
S _
8) M2A_SB/M2M_SB (M.2 Socket 3 Connectors)
The M.2 connectors support M.2 SATA SSDs or M.2 PCIe SSDs and support RAID configuration. Please
note that an M.2 PCIe SSD cannot be used to create a RAID set either with an M.2 SATA SSD or a SATA
hard drive. To create a RAID array with an M.2 PCIe SSD, you must set up the configuration in UEFI BIOS
mode. Refer to Chapter 3, "Configuring a RAID Set," for instructions on configuring a RAID array.
Follow the steps below to correctly install an M.2 SSD in the M.2 connector.
Step 1:
Use a screw driver to unfasten the screw and standoff from the motherboard. Locate the proper mounting
hole for the M.2 SSD to be installed and then screw the standoff first.
Step 2:
Slide the M.2 SSD into the connector at an angle.
Step 3:
Press the M.2 SSD down and then secure it with the screw.
B S_
B
5 3 1
SATA3
4 2 0
7
7
To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Settings\IO Ports\
SATA And RST Configuration," for more information.
_ 0
_ 0
110 80 60
80 60
_3
_3
Pin No. Definition
F
1 GND
2 TXP
1 3 TXN
4 GND
1
F
5 RXN
_ 0
6 RXP
7 GND
_ 0
_ F
_ F
F
F
M2A_SB
42
M2M_SB
42
U
U
- 15 -
S
S
S
S
Chipset supports RAID 0,
®