Gigabyte B460 HD3 User Manual page 41

A-2: Installation in Intel RST Premium With Intel Optane System Acceleration mode
If the SATA controller has been configured in Intel RST Premium With Intel Optane System Acceleration mode,
please follow the steps below:
1. After system restarts, go to the BIOS Setup, make sure CSM Support under the Boot menu is disabled.
2. Go to Settings\IO Ports\SATA And RST Configuration and make sure Use RST Legacy OROM is disabled
and RST Control PCIe Storage Devices is set to Manual. If you want to enable the Optane
in the M2Q_SB connector, set PCIe Storage Device on Port 21 to RST Controlled.
3. Enter the operating system, launch the Intel
enable Intel Optane
®
4. Launch the Intel Rapid Storage Technology utility from the Start menu and make sure the Intel
®
Memory has been enabled. If you want to accelerate the system drive, you can select specific folders, files, or
applications to accelerate using the Intel
used must have at least 32 GB capacity.)
• An Optane
• Do not abruptly remove the Optane
functioning correctly.
• If you want to change/remove the Optane
Storage Technology or Intel(R) Optane
• After enabling the Optane
Memory on the Intel
™
Optane
®
memory cannot be used to accelerate an M.2 PCIe SSD.
™
memory, the related BIOS settings will remain even after a BIOS update.
™
Rapid Storage Technology utility from the Start menu, and then
®
Optane Memory screen.
® ™
Memory Pinning function. (The Intel
™
memory. Doing so will cause the operating system to stop
™
memory, you must disable it using the Intel
™
Memory application first.
™
- 41 -
memory installed
™
Optane
® ™
Optane memory
® ™
Rapid
®