Amazon B07GDXCX87 Manual page 11

Installation
Step 6: Installing Floor Guide
If your door already has a groove in the bottom of the door:
1. With the door at open position, place the floor guide (F) into the center of the groove. (The floor
guide should not be sticking outside the edge of the door.)
2. Loosen the back door stop (C2) and slide the door backwards (enough to see the floor guide).
3. Screw the floor guide (F) into the floor using 2 screws (F1).
4. Slide the door forward and reposition the door stop (C2) and tighten.
If your door does not have a groove in the bottom of the door:
1. Loosen the anti-jumper disc turn (to where they are hanging over the front edge of the door).
2. Lift the door off the track and place on a flat surface.
3. Find the center of the door edge and draw a line that reaches the entire length of the door edge.
4. Using a router, make a groove in the bottom of the door.
5. Hang the door back on the track.
6. Turn the anti-jumper discs to where they are now centered on the door edge.
7. Follow the steps above (If your door already has a groove in the bottom of the door).
F1
F
1/4" (6 mm)
11