Setting Up - BT Relate SMS User Manual

Setting up

Please note that your handset is already
registered to the base station.
Situate your product close enough to the
telephone and mains power sockets so that the
cables will reach.
Make sure it is at least 1 metre away from other
electrical products to avoid interference.
Do not situate the product in the
bathroom or other humid areas.
Thread the power supply cable and line cord
through the square hole in the plinth before
fixing to the base.
Plug the power supply cable into the socket on
the underside of your base. The power cable
connector and socket are coloured red.
Please take care that the power supply and
telephone line cord are connected to the
correct sockets as incorrect placement could
damage your equipment.
7
Once connected, put the plinth back on the
base to prevent it from rocking on the table.
There are two positions for the plinth when
joining it to the base, both can be used for desk
mounting and one for wall mounting. Position
is for desk mounting only and position
desk or wall mounting (see wall mounting on
page 31).
Hold the black plastic square between thumb
and forefinger and peel off individual feet from
backing sheet as shown. These are to stop your
base from moving and to protect your work
surface.
If you decide on position , place 2 of the
rubber feet on the plinth and 2 on the base.
Plug the power adaptor into the wall socket and
switch on. When the power is switched on, the
button on your base will light up.
is for