Related Manuals for Directed Electronics 3200HS
Summary of Contents for Directed Electronics 3200HS
- Page 1 3 3 2 2 0 0 0 0 H H S S O O w w n n e e r r ’ ’ s s G G u u i i d d e e...
- Page 3 l l i i m m i i t t e e d d l l i i f f e e t t i i m m e e c c o o n n s s u u m m e e r r w w a a r r r r a a n n t t y y Directed Electronics, Inc.
- Page 4 CONSEQUENTIAL DAMAGES OF ANY KIND. IN THE EVENT OF A CLAIM OR A DISPUTE INVOLVING DIRECTED OR ITS SUBSIDIARY, THE PROPER VENUE SHALL BE SAN DIEGO COUNTY IN THE STATE OF CALIFORNIA. CALIFORNIA STATE LAWS AND APPLICABLE FEDERAL LAWS SHALL APPLY AND GOVERN THE DISPUTE.
-
Page 5: Table Of Contents
t t a a b b l l e e o o f f c c o o n n t t e e n n t t s s s s t t a a n n d d a a r r d d t t r r a a n n s s m m i i t t t t e e r r c c o o n n f f i i g g u u r r a a t t i i o o n n ................2 2 w w h h a a t t i i s s i i n n c c l l u u d d e e d d . - Page 6 s s t t a a n n d d a a r r d d t t r r a a n n s s m m i i t t t t e e r r c c o o n n f f i i g g u u r r a a t t i i o o n n controls the A A r r m m function.
- Page 7 w w h h a a t t i i s s i i n n c c l l u u d d e e d d The control module An XHF receiver/antenna A pair of four-button transmitters The red status LED indicator light A push-button Valet ®...
-
Page 8: System Maintenance
system maintenance The system requires no specific maintenance. Your remote is powered by a small, lightweight 3-volt lithium battery that will last approximately one year under normal use. When the battery begins to weaken, operating range will be reduced and the LED on the remote will dim. -
Page 9: Standard Configuration
t t r r a a n n s s m m i i t t t t e e r r f f u u n n c c t t i i o o n n s s The receiver uses a computer-based learn routine to learn the transmitter buttons. -
Page 10: Locking/Arming
Button The panic feature is controlled by pressing this button for one second.* Buttons An optional auxiliary convenience or expansion function that you have added to your system can be activated by pressing these buttons simultaneously. The auxiliary output controls_________________________. u u s s i i n n g g y y o o u u r r s s y y s s t t e e m m locking/arming Pressing... -
Page 11: Unlocking/Disarming
turned off. After the ignition has been turned off, the status LED will flash rapidly to indicate that the system is in Passive Mode. If Passive Mode has been programmed on, then it is also possible to program the system for Passive Locking. With Passive Locking, the vehicle doors lock automatically at the same time that the Failsafe Starter Kill is activated. -
Page 12: Disabling The System Without A Transmitter
disabling the system without a transmitter If your remote transmitter is lost or damaged, you can manually override the system. To do this, you must have the vehicle's igni- tion key and know where the Valet check with the installer for the location of the Valet To disarm the security system, the ignition to the ON posi- tion. -
Page 13: Valet Mode
valet mode You can prevent your system from automatically activating the Failsafe ® Starter Kill and locking the doors by using Valet This is very useful when washing the vehicle or having it serviced. In Valet ® Mode, the starter kill cannot be activated, even with the transmitter, but all convenience functions (door locks, remote start, etc.) will continue to work normally. - Page 14 o o w w n n e e r r r r e e c c o o g g n n i i t t i i o o n n Owner Recognition is a feature available exclusively from Directed. Using the Directed Bitwriter, a hand-held programming tool, your dealer can program many of the system settings.
- Page 15 p p r r o o g g r r a a m m m m i i n n g g o o p p t t i i o o n n s s Programming options control your system's normal, operational set-up.
- Page 16 g g l l o o s s s s a a r r y y o o f f t t e e r r m m s s The “brain” of your system. Usually hidden under Control Unit: the dash area of the vehicle.
- Page 17 The domelight will illuminate for 30 Domelight Supervision: seconds each time the system is disarmed using the remote. This is useful for seeing inside the vehicle at night prior to entering it. Your system is capable of controlling Power Door Lock Control: many types of power door lock systems;...
- Page 18 QUICK REFERENCE GUIDE To lock/arm using your remote To arm the system press for one second. The doors will lock (if connected). The LED will begin to flash. The Failsafe® Starter Kill will prevent the vehicle’s starter from cranking if it has been installed. The vehi- cle’s horn (if connected) will honk and the parking lights will flash once to confirm arming of the system.
- Page 19 The company behind this system is Directed Electronics, Inc. Since its inception, Directed Electronics has had one purpose, to provide consumers with the finest vehicle security and car stereo products and accessories available. The recipient of nearly 100 patents and Innovations Awards in the field of advanced electronic technology, DIRECTED is ISO 9001 registered.