Acg 2 (Anti-Codegrabbing 2™); Adding New Remote Controls - Clifford IntelliGuard 9000 Complete Owner's Manual

Press the master remote LevelShift button twice, then button 1 or press buttons
valet mode.
If you have this option, press the master remote LevelShift button once, then button 2 or press buttons
(companion remote) after disarming to fully open the windows controlled by SmartWindows 4. On hot days, press this button
combination right after arming to vent the windows slightly while the system remains armed.
Other system features and options can be accessed as noted in the following Quick Reference table:
ACG 2 protects you and your automobile from code-grabbing devices. Code-grabbers record, from hundreds of feet away, the code sent by your car alarm
remote control (code-grabbers are very similar to, but simpler than, cellphone "cloning" devices). The thief then plays back the code when you're gone,
instantly disarming the alarm and unlocking the doors. It's like leaving your keys and remote in the door. Many non-Clifford alarms can be defeated that
easily, and some of the latest "smart" code-grabbers can even decipher the code hopping/jumping sequence used by other car alarm manufacturers. In
contrast, your IntelliGuard 9000 uses complex digital signal processing and unbreachable code encryption to randomly change the digital code every time
you use the remote control. Your remotes will never transmit the same code twice, and the control unit will never accept the same code twice. Thus the
code played back by the code-grabber — even the latest generation smart code-grabbers — will never be accepted by your IntelliGuard 9000 system.
For other drivers, or to control Clifford G4 systems on your other cars with the same remote, you can buy additional remote controls from any Clifford
Dealer (or direct from the Customer Service Department of your nearest Clifford Headquarters listed on the front cover) and program them into the
system yourself. IntelliGuard 9000 will respond to as many as four remote controls.
NOTE: Clifford G4 systems will respond only to G4-type ACG 2 remote controls. Older Clifford ACG and non-ACG
remote controls are not compatible with G4 systems.
To add a new master 5-button remote control, use the Add new master remote feature (column 1, row 1) of the User-selectable features table. To add a new
companion 4-button remote, program each button and button combination to the specific functions noted in column 4.
QUICK REFERENCE: REMOTE CONTROL FUNCTIONS
Function
ACG 2 (Anti-CodeGrabbing 2™)

Adding new remote controls

and ✱ (companion remote) to enable/exit
and
no
no
✱
no
+
✱
no
1 time
1 time
+
✱
1 time
+
1 time
+
✱
2 times
+
2 times
+
2 times
2 times
3 times
3 times
3 times
3 times
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4