Table of Contents
Advertisement
PARTS
1. On/off switch
2. Pivoting head and cutter assembly
3. Flexing heads
4. Hairpocket
5. Charging indicator light
6. Low/Full/Charging indicator light
GETTING STARTED
It is recommended that you use your new shaver daily for up to four weeks to allow time
for your beard and skin to become accustomed to the new shaving system.
CHARGING YOUR SHAVER
•
Ensure the appliance is turned off.
•
Connect the shaver to the adaptor and then to the mains.
•
Charge for at least 24 hours when using for the first time.
•
Allow 4 hours for a full charge.
•
When charging, the green indicator light will show solid (PR1350) or slowly flash
(PR1370). When fully charged, the green indicator light will turn off (PR1350) or the
green indicator light will show solid for 5 minutes and then turn off (PR1370).
•
The LED indicator on PR1370 will rapidly flash to indicate that the battery is running
low.
•
To preserve the life of your batteries, let them run out every 6 months then recharge
for 24 hours.
•
The shaver automatically adjusts to a mains voltage between 100V and 240V.
INSTRUCTIONS FOR USE
SHAVING
•
Note: PR1350 and PR1370 can only be used cordless.
•
Make sure your shaver is properly charged.
•
Switch the shaver on.
•
Stretch the skin with your free hand so the hairs stand upright.
•
Only apply light pressure on the shaving head while shaving (pressing too hard can
damage the heads and make them vulnerable to breakage).
•
Use short, circular strokes.
TRIMMING
•
Slide the trimmer button to release the detail trimmer.
•
Hold the trimmer at a right angle to your skin.
7. Detail trimmer
8. Trimmer release button
9. Power port
10. Adaptor (not shown)
11. Cleaning brush (not shown)
12. Head guard
5
Advertisement
Table of Contents
