Mounting And Installation; Installation - SMC Networks D-S9 Series Operation Manual

Mounting and Installation

■Installation

When mounting the Auto switch to actuator it should be done with clamp for actuator.
"How to mount" depends on actuator type and tube I.D. Please refer the actuator catalogue.
When the Auto switch is mounted newly, please prepare the clamp for actuator after confirms that the
actuator built in magnet.
•Proper tightening torque
The tightening torque of the M3 mounting screw must be 0.5 Nm (5.1 kgf•cm).
< D-S79, D-S7P, D-T79, D-T79C >
1. Auto switch mounting
Loosen the cross recessed round head screw (2), and insert the arm of the auto switch.
2. Auto switch securing
Set the auto switch so that it is in contact with the switch block, and tighten the cross recessed round
head screw (2).
: Proper tightening torque: 0.4 to 0.6 Nm
-12-
No.D-※S-OMB0023-B