Storage; Storage After Use - Echo CS-2511T Operator's Manual

STORAGE

STORAGE

Storage After Use

• Inspect and adjust every part of the chain saw.
• Completely clean every part and repair if necessary.
• Apply thin coating of oil on metal parts to prevent rust.
• Remove chain and guide bar.
• Drain fuel tank completely. Press purge bulb 6-7 times to remove
remaining fuel from carburetor then drain the tank again. Close choke,
start and run the engine until it stops due to lack of fuel.
• Allow engine to cool. Remove the spark plug lead from the spark plug.
Remove the spark plug. Pour 7 cc (0.25 oz.) of fresh, clean, two-stroke
engine oil into the cylinder through the spark plug hole.
• Store in a dry area, free from dust.
Do not store in an enclosure where fuel fumes may accumulate
or reach an open flame or spark.
Do not lend or rent your chain saw without the Operator's
Manual.
Note:
• For future reference, you should keep this Operator's Manual.
• If this Operator's Manual becomes illegible or is lost, please contact
your ECHO dealer, or go to www.echo-usa.com.
56
CS-2511T
X7503332503
© 11/19 ECHO Incorporated