Using The Touch Screen's Zoom Controls; Using An Optional Remote Controller - Canon VIXIA HF G50 Instruction Manual

Zooming
To use high-speed zoom in standby mode
When high-speed zoom is activated and
to [Y] (variable zoom speed), in record standby mode you will be able to zoom at the highest speed
available ([Z Fast]). Nevertheless, the zoom speed while recording will be determined by the [Zoom
Speed Level] setting.
1 Select [High-Speed Zoom].
> [v ! Camera Setup]
52
2 Select [i On] and then select [X].
NOTES
• When pre-recording is activated, the zoom speed will be determined by the [Zoom Speed Level]
setting even in record standby mode.
• When [Zoom Speed Level] is set to [Z Fast], the zoom speed will not change even in record
standby mode.

Using the Touch Screen's Zoom Controls

1 Open the onscreen zoom controls.
>
[FUNC] [R Zoom]
• The zoom controls appear at the bottom the screen.
2 Touch the zoom controls to operate the zoom.
• Touch anywhere within the V area to zoom out or
anywhere within the U area to zoom in. Touch closer to
the center for a slow zoom; touch closer to the V/U
icons for faster zooms.
3 Select [X].

Using an Optional Remote Controller

The zoom speeds when using the optional RC-V100 Remote Controller or a commercially available
remote control connected to the REMOTE terminal are different.
Zoom speeds for remote operation
Accessory
RC-V100 Remote Controller
(optional)
Commercially available
remote controls
>
>
[High-Speed Zoom]
Variable speed: The greater the angle at which the RC-V100's ZOOM dial is rotated
from the center, the faster the zoom.
If the remote control does not support variable zoom: Constant zoom speed.
If the remote control supports variable zoom: Variable zoom according to the remote
control's settings.
>
[v Camera Setup]
Zoom speed
[Grip Zoom Speed] is set