The Following Fault Message Appears In The Display And The Program Has Been Cancelled - Miele WWH 860 Operating Instructions Manual

Frequently Asked Questions
The following fault message appears in the display and the
program has been cancelled
Message

Water intake See


Drainage See 

 Service
Waterproof syst. 

 Service Fault F
To switch off the fault message: Turn the program selector to the  position and
switch the washing machine off.
60
Possible cause and remedy
The water inlet is blocked or restricted.
 Check whether the tap is turned on properly.
 Check whether the inlet hose is kinked.
 Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
 Clean the filter.
The drain is blocked or restricted.
The drain hose has been fixed too high.
 Clean the filter and the pump.
 The maximum drain height is 1 m.
The water protection system has engaged.
 Close the tap.
 Contact the Service department.
There is a fault.
 Disconnect the washing machine from the
electricity supply, either by switching it off at the
wall socket and withdrawing the plug, or by
disconnecting it at the circuit breaker.
 Wait at least 2 minutes before reconnecting the
washing machine to the electricity supply.
 Then switch the washing machine on again.
 Restart the program.
If the fault message appears again, contact the
Service department.