Realtek LAN Controller
This item allows you to enable or disable the Realtek LAN controllers. Configuration options:
[Disabled] [Enabled]
USB power delivery in Soft Off state (S5)
[Enabled]
[Disabled]
3.6.8
APM Configuration
The items in this menu allow you to set system wake and sleep settings.
ErP Ready
This item allows you to switch off some power at S4+S5 or S5 to get the system ready
for ErP requirement. When set to [Enabled], all other PME options are switched off.
Configuration options: [Disabled] [Enable(S4+S5)] [Enable(S5)]
3.6.9
USB Configuration
The items in this menu allow you to change the USB-related features.
The Mass Storage Devices item shows the auto-detected values. If no USB device is
detected, the item shows None.
USB Single Port Control
This item allows you to enable or disable the individual USB ports.
Refer to section 1.1.2 Motherboard layout for the location of the USB ports.
3.6.10
Network Stack Configuration
The items in this menu allow you to configure Ipv4 / Ipv6 PXE support.
3.6.11
HDD/SSD SMART Information
The items in this menu display the SMART information of the connected devices.
3-18
The USB port will provide power to your devices even when the system is
in Power State S5.
Disables this function.
Chapter 3: BIOS Setup