Suzuki DF100A Owner's Manual page 51

3. Remove the bolt 1 and nut 2 securing the
bracket 3 of the fuel filter.
NOTICE
Improperly loosening the filter cup can
cause sensor lead wire damage.
• Be careful not to twist the sensor lead
wire when removing the filter cup.
• Disconnect the lead wire connector
before removing the filter cup.
4. Push the connector lock tab "a", then discon-
nect the water sensor lead wire connector
4.
"a"
5. Place a rag under the filter before removal to
catch any spilled fuel.
6. Separate the filter cup 5 from the cap 6 by
turning the filter cup counterclockwise.
7. Drain the fuel and water in the filter cup into
a suitable container.
8. Pull out the filter element 7. Inspect the filter
element 7, O-ring 8 and seal ring 9 for
damage. If they are damaged, replace them.
9. Wash the filter element with clean solvent
and dry it.
10. Reinstall the seal ring and filter element in
their original positions.
11. Verify that the O-ring is in place in the top of
the filter cup and screw the filter cup back
into place.
12. Connect the water sensor lead wire connec-
tor 4.
13. Reinstall the fuel filter with bracket by secur-
ing the bolt and nut.
14. Restart the engine and check that there are
no leaks around the fuel filter.
NOTE:
If any water exists in the fuel filter cup, remove
the cup and drain the water. Always dispose of
excess fuel safely. For questions, consult your
authorized Suzuki marine dealer.
49