Suzuki DF100A Owner's Manual page 21

4. Top mount type
Using the throttle only function of the remote
control box, move the control handle forward
until the caution buzzer sounds one time.
Side mount type
Using the throttle only function of the remote
control box, move the warm-up lever upward
until the caution buzzer sounds one time.
Side mount
type
UP
PTT switch
5. Press the "UP" side of the PTT switch for
three seconds and the buzzer will sound
twice briefly indicating the setting has been
canceled.
6. Return the throttle to the fully closed posi-
tion.
SETTING THE TILT UPPER POSITION
LIMIT
7. Press the "UP" side of the PTT switch so
that the optimum full tilt up position for the
boat can be obtained.
8. Turn the ignition key to the "ON" position.
9. Pull out the emergency stop switch lock
plate.
10. Make sure that remote control handle is in
"NEUTRAL".
11. Top mount type
Using the throttle only function of the
remote control box, move the control handle
forward until the caution buzzer sounds one
time.
Side mount type
Using the throttle only function of the
remote control box, move the warm-up lever
upward until the caution buzzer sounds one
time.
Top mount
type
UP
PTT switch
12. Press the "UP" side of PTT switch three
times within three seconds. The buzzer will
sound one time briefly indicating the setting
has been accepted.
13. Return the throttle to the fully closed posi-
tion and install the lock plate on the emer-
gency switch. Operate the full tilt up and full
down operations several times by pressing
the PTT switch and check that the setting of
both the trim lower limit and tilt upper limit
are properly set.
 WARNING
Setting of the tilt upper limit position will
not prevent the outboard motor from tilt-
ing fully up and contacting the motor well
if the motor's lower unit hits an object at
high speed. Such tilting could damage
your motor and boat and injure the boat
occupants.
Keep all occupants away from the motor
when operating at high speed.
19