Setting Up; Plan The Location - BT classic 1100 Executive User Manual

Setting up

Please note that your handset is already
registered to the base station.

Plan the location.

Situate your product close enough to the
telephone and mains power sockets so that
the cables will reach.
Make sure it is at least 1 metre away from
other electrical products to avoid interference.
Do not situate the product in the bathroom or
other humid areas.
Thread the power supply cable and line cord
through the square hole in the plinth before
fixing to the base.
Plug the power supply cable into the socket
on the underside of your base. The power
cable connector and socket are coloured red.
Please take care that the power supply and
telephone line cord are connected to the
correct sockets as incorrect placement could
damage your equipment.
Once connected, put the plinth back on the
base to prevent it from rocking on the table.
There are two positions for the plinth when
joining it to the base both can be used for
desk mounting and one of them for wall
mounting (see wall mounting on page 27).
Plug the power adaptor into the wall socket
and switch on. When the power is switched on,
the button on your base will light up.
Do not connect the telephone line cord to
the phone socket until your handset is fully
charged. This will prevent the risk of the
phone being answered before the battery is
charged. Answering the phone before the
battery is fully charged may prevent it from
reaching its optimum capacity.
10