Quadra-Fire 57ST-ACC-AU Installation Manual page 17

9. Install ARS latch by sliding latch assembly over 2
threaded studs protruding from the bottom on the left
hand side of the appliance. Secure by using two nuts
use 7/16 socket wrench.
10. Add knob to handle rod (Figure 17.1).
11. Using two bolts and two flange nuts to secure ARS
channel using 3/8 open end wrench and 7/16 socket
wrench (Figure 17.2).
Do NOT operate before fully assembling
components. Burning your appliance without a
pedestal or leg kit attached:
• Will void your warranty.
• May result in property damage or personal injury.
Door latch with the
ash door rod locked
in place
Figure 17.1
Insert two bolts through ARS
Channel, Appliance, Gasket, and
ARS Door Assembly; secure with
two nuts.
Figure 17.2
16 August, 2018
WARNING
Knob
Ash Door Rod shown
in installed position
Installing Ped Kit
1. Follow Beginning installing the ARS system
instructions provided on page 16.
2. Slide pedestal over adapter on bottom of appliance and
secure with four screws using Phillips head screwdriver
(Figure 17.3).
3. Install ARS Spacer on left hand side with one bolt using
Phillips head screwdriver (Figure 17.4).
4. Carefully stand appliance up and place in desired
location.
Figure 17.3
Ash Removal
Spacer
Figure 17.4
7038-248A
5700 Step Top AU Wood Appliance
Ash Removel
Drawer
Adapters
17