LG WTG7532W Owner's Manual page 39

Symptoms
Control panel has powered
off due to inactivity.
Washing machine is
unplugged.
Water supply is turned off.
Controls are not set properly.
Door is open.
Circuit breaker/fuse is
tripped/blown.
Washing machine
Control needs to be reset.
will not operate
Start/Pause was not pressed
after a cycle was set.
Extremely low water
pressure.
Washing machine is too cold.
Washing machine is heating
the water or making vapour.
(some models only)
38
Reason
• This is normal. Press the Power button
to turn the washing machine back on.
• Make sure the power cord is plugged
securely into a working outlet.
• Turn both hot and cold taps fully on.
• Make sure the cycle was set correctly,
close the door and press the Start/Pause
button.
• Close the door and make sure that
nothing is caught under the door
preventing it from closing completely.
• Check house circuit breakers/fuses.
Replace fuses or reset breaker. The
washing machine should be on a
dedicated circuit. The washing machine
will resume the cycle from where it
stopped once power is restored.
• Press the Power button, then reselect
the desired cycle and press the Start/
Pause button.
• Press the Power button then reselect the
desired cycle and press the Start/Pause
button. The washing machine will shut off
if the Start/Pause button is not pressed
within 60 minutes.
• Check another tap in the house to make
sure that household water pressure is
adequate.
• If the washing machine has been
exposed to temperatures below freezing
for an extended period of time, allow it to
warm up before pressing the Power
button.
• The washing machine drum may stop
operating temporarily during certain
cycles, while water is safely heated to a
set temperature.
EN
Solution