Installing the Switch Chassis
Starting the Switch
c) Tighten the 10-32 screws to 20 in-lb (2.26 N·m) or tighten the 12-24 screws to 30 in-lb (3.39 N·m).
Starting the Switch
You start the switch by connecting it to its dedicated power source. If you need n+1 redundancy, you must
connect each of the power supplies to one or two power sources. If you need n+n redundancy, you must
connect each power supply in a switch to a different power source.
Note
This equipment is designed to boot up in less than 30 minutes, dependent on its neighboring devices being
fully up and running.
Cisco Nexus 93240YC-FX2 NX-OS Mode Switch Hardware Installation Guide
30