Table of Contents
Advertisement
16
en | Installation
8.
9.
10. If the camera is correctly focused, briefly press the Menu button to access the video
11. Briefly press Menu to change the video analog output format as required.
12. When the correct format is shown, press Menu for a longer period to exit the wizard.
5.6.2
Reset
Use the factory reset button to restore the unit to its original settings. Any changes to the
settings are overwritten by the factory defaults. A reset may be necessary, for example, if the
unit has invalid settings that prevent it from functioning as desired.
5.7
Mount inner and outer dome
When the camera position is set and all adjustments have been made, disconnect the service
cable from the video jack.
To attach the inner and outer dome:
1.
2.
3.
4.
03.2019 | V2.0 | AM18-Q0711
When you reach the desired zoom position, use a long press of the Menu button to set
the zoom position and to re-focus.
If the camera is not in focus, press Menu for a longer time to re-run the auto focus.
analog output format screen.
Reset
Place the desiccant sachet inside the inner dome to prevent damp.
Align the inner dome fin with the slot in the camera frame, and gently click the inner
dome into place in its mount seal
Check that the lens can move freely in the dome opening.
Mount the outer dome by screwing in the 3 attachment bolts.
Installation manual
FLEXIDOME IP starlight 6000 VR
Bosch Security Systems B.V.
Advertisement
Table of Contents
