Mounting The Bar And Chain - Stihl MS 193 T Instruction Manual

English

Mounting the Bar and Chain

Disengaging the chain brake
Pull the hand guard (4) towards the
N
control handle until there is an
audible click – the chain is
disengaged.
Removing the chain sprocket cover
6
5
Unscrew the nut (5) and remove the
N
cover (6).
12
Mounting the guide bar
4
Turn the screw (7)
N
counterclockwise until the tensioner
slide (8) butts against the left end of
the housing slot.
Fit the guide bar over the stud (9)
N
and engage the peg of the tensioner
slide in the hole (10).
Fitting the Chain
WARNING
Wear work gloves to protect your hands
from the sharp cutters.
7
8
9
10
11
Fit chain around the sprocket (11)
N
and over the guide bar – the cutting
edges on top of the bar must point to
the bar nose.
7
Turn the screw (7) clockwise until
N
there is very little chain sag on the
underside of the bar – and the drive
link tangs are engaged in the bar
groove.
MS 193 T