Stihl MS 193 Instruction Manual page 21

Mounting the guide bar
7
8
Turn the screw (7)
N
counterclockwise until the tensioner
slide (8) butts against the left end of
the housing slot.
9
10
Fit the guide bar over the stud (9)
N
and engage the peg of the tensioner
slide in the hole (10).
Fitting the chain
WARNING
Wear work gloves to protect your hands
from the sharp cutters.
MS 193 C
11
Fit chain around the sprocket (11)
N
and over the guide bar – the cutting
edges on top of the bar must point to
the bar nose.
7
Turn the tensioning screw (7)
N
clockwise until there is very little
chain sag on the underside of the
bar – and the drive link tangs are
engaged in the bar groove.
Refit the chain sprocket cover –
N
the pivot pin on the hand guard must
engage the sleeve – and then screw
the nut onto the stud fingertight.
Go to chapter on "Tensioning the
N
Saw Chain"
English
19