Remote Control Preparation - Curtis DVD1047 User Manual

DVD PLAYER

REMOTE CONTROL PREPARATION

Battery Installation
Insert the batteries while observing the positive (+)
and Negative (-) polarities as Figure A.
Service life of batteries
The batteries normally last for a year although this
depends on the operation and on how often the remote
control is used.
If the remote control unit fails to work even when it is
operated near the player, replace the batteries with
new ones. Use size AAA UM-4 batteries (2 pieces).
Notes:
Do not use rechargeable (Ni-Cd) batteries.
Do not attempts to recharge, short circuit,
disassemble, heat or throw the batteries into
Do not drop, step on the remote control,
it may damage the parts or lead to
Do not mix old and new batteries. If the remote
control is not going
the batteries. Otherwise, electrolyte may leak and
lead to malfunctioning or even burns by electrolyte.
Wipe away any electrolyte
control, and install
If the leaking electrolyte has
of your body, wash
Remote control operation range .
The operation range of the
than 5m from and within about 60 degree wide in
front of the unit (Figure B).
The operating distance may vary
brightness of the room.
Notes:
Do not point bright lights to the remote control sensor.
Do not place objects between the remote control and
the remote control sensor.
Do not use this remote control together with the
remote control of any other equipment.
otherwise
malfunctioning.
to be used for a long time remove
leaking inside the remote
new batteries.
contact with some parts
it off thoroughly with water.
remote control is no more
according to the
fire.
Among 5 meters
10
Remoto control sensor
DVD 1047