Table of Contents
Advertisement
Changing the Engine Oil
Change the engine oil after the first 2 operating hours;
change it yearly thereafter.
Run the engine a few minutes before changing the oil
to warm it. Warm oil flows better and carries more
contaminants.
1. Refer to Preparing for Maintenance.
2. Remove the dipstick (Figure 31).
Figure 31
3. Tip the mower onto the right side to drain the used oil
out through the oil fill tube (Figure 32).
Figure 32
4. Slowly pour oil into the oil fill tube until the oil level
reaches the Full line on the dipstick (Figure 33). Do not
overfill. (Max. fill: 20 oz., type: SAE 30W detergent
oil with an API service classification of SF, SG, SH, SJ,
SL, or higher.)
Figure 33
5. Install the dipstick securely.
6. Dispose of the used oil properly at a local recycling
center.
Charging the Battery
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after handling
battery.
Charge the battery for 24 hours initially, then monthly
(every 25 starts) or as needed. Always use the charger in a
sheltered area and charge the battery at room termperature
(70°F or 22°C) whenever possible.
1. Connect the charger to the mower wire harness located
below the ignition key (Figure 34).
Figure 34
2. Plug the charger into a wall outlet.
Note: When the battery no longer holds a charge, recycle
or dispose of the lead-acid battery according to local codes.
Replacing the Fuse
If the battery does not charge or the engine does not turn
with the electric starter, the fuse may be blown. Replace it
with a 40-amp plug-in type fuse. Refer to Installing the Fuse.
Lubricating the Wheel Gears
1. Remove the wheel bolts on the rear wheels and remove
the rear wheels.
2. Apply a lubricating oil to the inner and outer sides of
the gear as shown in Figure 35.
Figure 35
3. Install the rear wheels.
13
Advertisement
Table of Contents
