Table of Contents
Advertisement
1. Throttle control
2. Speed control lever
3. Ignition switch
4. Neutral lock
5. Operator Presence
Control levers (OPC)
Throttle Control
The throttle control has three positions: Choke, Fast,
and Slow.
Operator Presence Control (OPC)
Levers
When you squeeze the OPC levers against the handles,
the OPC system senses that the operator is in the
normal operating position. When you release the OPC
levers, the OPC system senses that the operator has left
the normal operating position, and the system will stop
the engine if either the speed control lever is not in the
neutral position or the blade control (PTO) knob is
engaged.
Blade Control Knob (PTO)
The blade control knob (PTO) is used to engage and
disengage the drive belt to drive the mower blades
with the OPC levers pressed against the handles. Pull
the knob up to engage the blades and push down to
disengage the blades.
Figure 5
6. Handle
7. Drive Lever
8. Blade control knob (PTO)
9. Choke
10. Fuel shut-off valve
Ignition Switch
This switch is used in conjunction with recoil starter and
has two positions: Run and Off.
Speed Control Lever
This machine has a variable speed control with a neutral
position. This controls how fast the machine will travel
forward.
Drive Levers
Release drive levers to engage forward traction operation
and squeeze the levers until an increase in force is felt
to go into neutral position and continue to squeeze to
go in reverse. Squeeze right side of drive lever to turn
right and left side to turn left.
Neutral Lock
Squeeze drive levers back until an increase in force is felt
and move locks to the rear for neutral lock.
Recoil Starter
Pull the recoil starter handle to start the engine
(Figure 4).
Fuel Shut-off Valve
Close the fuel shut-off valve when transporting or
storing mower.
Choke
Use the choke to start a cold engine.
Specifications
Note: Specifications and design are subject to change
without notice.
36 inch mowers:
Width with deflector down
Length
Height
Weight
Attachments/Accessories
A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
13
46.6 inches (118.4 cm)
80 inches (203.2 cm)
44 inches (111.8 cm)
532 lb (241 kg)
Advertisement
Table of Contents
