Lennox Merit Plus MPD35ST-NM-B Care And Operation Instructions Manual page 14

10. Place Log (E) as shown in Figure 11.
Position The Round End Of Log (E) Against The Notch Of
Log (D) Here. Two Charred Spots Face The Front
C
Position Small End of Log
(E) on The Notch of Log
(C) Here
11. Place Log (F) as shown in Figure 12.
(Valve Access Side)
Figure 12
14
Order Parts at: PartsFor.com or 866-607-2787
E
D
(Valve Access Side)
Figure 11
F Log (F) Sits in
Front of The Grate
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Order Parts at: PartsFor.com or 866-607-2787
WARNING
• DO NOT attempt to install the logs until the appli-
ance installation has been completed, the gas line
connected and tested for leaks and the initial burner
operation has been checked out.
• The size and position of the log set was engineered
to give the appliance a safe, reliable and attractive
flame pattern. Any attempt to use a different log
set in the fireplace will void the warranty and will
result in incomplete combustion, sooting, and poor
flame quality.
• Logs get very hot and will remain hot up to one
hour after gas supply is turned off. Handle only when
logs are cool. Turn off all electricity to the appliance
before you install grate, volcanic stone, vermiculite,
embers and logs.
• This appliance is not designed to burn wood. Any
attempt to do so could cause irreparable damage to
the appliance and prove hazardous to your safety.
• If logs are not installed according to the log
installation instructions, flame impingement and
improper combustion could occur and result in soot
and/or excessive production of carbon monoxide
(CO), a colorless, odorless, toxic gas.