Table of Contents
Advertisement
CONNECTING YOUR MONITOR
Ensure that both the computer and the monitor are switched off.
Connect the computer to the monitor with the signal cable.
Connect the computer to the monitor with the USB Cable.
Connect the Power Cable to the monitor fi rst and then to the power supply.
Turn on your monitor (Main Power Switch and Power Switch) and computer.
The signal cables used for connecting the computer and monitor may vary with the
NOTE
type of computer used. An incorrect connection may cause serious damage to both
the monitor and the computer. The cable supplied with the monitor is for a standard
connector. If a special cable is required please contact your local iiyama dealer or
regional iiyama offi ce.
Make sure you tighten the fi nger screws at each end of the Signal Cable.
Don't connect the RS-232C cable and the USB cable to the computer at the same time.
And cannot use those at the same time.
When USB cable connected than wait for 5 seconds and the touch function is ready to
go. It can be activated by pen, fi nger or any other pointer.
[Example of Connection]
POWER
VOL+
VOL-
AUTO/UP
SOURCE/DOWN
MENU
LED
IR
Power Cable
(Accessory)
[ Collect Cables ]
Insert the Clamper into the Hole.
Collect cables at the back.
Secure the cables using a clamper.
<Back>
AC IN
USB
COM IN
HDMI
DVI IN
VGA
AUDIO
IN
IN
Audio Cable (Not Included)
VGA(D-sub) Signal Cable
DVI-D Cable (Accessory)
RS-232C Cable (Not Included)
USB Cable (Accessory)
HDMI Cable (Not Included)
(Accessory)
Computer
AV Equipment
AC IN
USB
COM IN
HDMI
DVI IN
VGA
AUDIO
IN
IN
IN
BEFORE YOU OPERATE THE MONITOR 15
Advertisement
Table of Contents
