Installation
1.
According to the model, mark out the drill hole points A, B, C, D in the location where you wish to install
the range hood. Use 8mm drill bits to drill holes in points A, B, C, D. Use a drill with a 4mm drill bit to mount
the bottom part of the duct respecting the maximum / minimum height dimensions.
2.
Insert ø 10 mm dowels into the drilled holes A, B, C, D and secure fi rmly. You can also use a hammer. Check
that the dowels are inserted correctly, that they are not moving in any way and that they cannot be pulled
out.
Then insert 2 x 6mm Ø 4 mm bolts into holes A, B with the installed dowels. Do not tighten fully.
Copyright © 2012, Fast ČR, a. s.
Electric cooktop
Kitchen
workbench
Gas cooktop
EN - 7
04/2012