Carbon Fi Lter - Philco PEC 9405 User Manual

2. Bends and deviations in the aluminium fl ue pipe reduce the exhaust performance, so it is essential that the
pipe is bent as little as possible.
Completing the installation
1. Insert 2 x 6mm Ø 4 mm bolts into holes C, D with the installed dowels. Do not tighten fully.
2. Place the internal and outer part of the chimney on the bolts in holes C, D according to the illustrations
below and tighten these bolts. Then use the 3.9 x 9.5 bolts to secure the chimney to the frame of the range
hood.

Carbon fi lter

If you are using the range hood without an air exhaust, it is necessary to use a carbon fi lter. The carbon fi lter is
not included. Contact your vendor or an authorised service centre to purchase this fi lter.

Before installing or replacing the carbon fi lter, check that the appliance is turned off and disconnected
from the power socket or that the respective circuit breaker is turned off .

It is necessary to replace the carbon fi lter regularly every 3 – 5 months depending on how much the
appliance is used.

Never wash the carbon fi lter in water unless the manufacturer states otherwise.

Aluminium fi lters must always be installed even when the carbon fi lter is not installed. Do not use the
appliance without the aluminium fi lter installed.
Copyright © 2012, Fast ČR, a. s.
Right Wrong
EN - 9
04/2012