Table of Contents
Advertisement
■
Installing / Removing batteries
Note the correct polarity
(+ or -)
Note
●
It is recommended to hold Touch Pad Controller with
your hand when using.
●
The battery power will be used whenever you use
Touch Pad Controller (including the touch of the touch
pad) even if not operating the TV. It may decrease the
battery life.
●
Some operations differ depending on the application.
Indicator / Control panel
●
When pressing 4, 5, 6 buttons, the control panel
guide appears on the right side of the screen for 3
seconds to highlight which button has been pressed.
Slide open
1
1 Remote control signal receiver
●
Close
2 Ambient sensor
●
3 Power LED
●
4 Input mode selection
●
[Main Menu]
●
OK (when in the menu system)
5 Channel Up / Down
●
6 Volume Up / Down
●
7 Mains power On / Off switch
●
4
5
6
7
2 3
Rear side of the TV
Do not place any objects between the TV remote
control signal receiver and remote control.
Senses brightness to adjust picture quality when
[Ambient Sensor] in the Picture Menu is set to
[On].
Red: Standby
Green: On
Orange: Standby with some functions (recording,
etc.) active
The LED blinks when the TV receives a command
from the remote control.
Press repeatedly until you reach the desired mode.
Press and hold for about 3 seconds to display main
menu.
Cursor Up / Down (when in the menu system)
Cursor Left / Right (when in the menu system)
Use to switch the mains power.
13
English
Advertisement
Table of Contents
