Installing The Cable Management Cover (Optional Accessory) - ViewSonic PJD7830HDL User Manual

Resetting the filter timer
5. Open the OSD menu and go to the SYSTEM SETTING: ADVANCED > Filter
Settings menu.
6. Press Enter and the Filter Settings page is displayed.
7. Highlight Reset Filter Hours and press Enter. A warning message is displayed
asking if you want to reset the filter timer.
8. Highlight Reset and press Enter. The lamp timer will be reset to '0'.
Caution
• Remember to use Filter Mode to Off in the SYSTEM SETTING: ADVANCED > Filter
Settings menu when using the projector with the dust filter removed. Setting Filter Mode
to Off does not reset the filter timer. The timer will continue counting the next time you
fit the filter back on and set Filter Mode to On.
Installing the cable management cover (optional
accessory)
1. Make sure that all the cables are properly connected to the projector.
2. Attach the cable management cover to the back of the projector.
3. Tighten the screws that secure the cable management cover.
46