Dhcp Client List - Tenda F303 Manual

! Note:
1. Web pages are not able to open if DNS server addresses are entered
incorrectly.
2. Do remember to restart the device to activate new settings when you
finish all settings.
3.8 DHCP
The Dynamic Host Configuration Protocol (DHCP) is an automatic
configuration protocol used on IP networks. If you enable the built-in
DHCP server on the device, it will automatically configure the TCP/IP
settings for all your LAN computers (including IP address, subnet mask,
gateway and DNS etc), eliminating the need of manual intervention. Just
be sure to set all computers on your LAN to be DHCP clients by selecting
"Obtain an IP Address Automatically" respectively on each such PC.
When turned on, these PCs will automatically load IP information from the
DHCP server. (This feature is enabled by default. Do NOT disable it unless
necessary)
!

3.9 DHCP Client List

DHCP Client List displays information of devices that have obtained IP
addresses from the device's DHCP Server. If you would like some devices
on your network to always get the same IP addresses, you can manually
add a static DHCP reservation entry for each such device.