Touch Console - Settings Tab; Touch Console - Default Tab - Vision Fitness X20 Service Manual

2.6 Engineering Mode Overview – Touch Console – Continued
2.6.2 Touch Console – Settings Tab
The Settings Tab used to set the Machine Type, Model and if the Energy Saver is turned on.
Setting: Pressing the
type to select the appropriate machine, TREADMILL, ELLIPTICAL or BIKE.
Use the same procedure as Machine Type to set the Model Type, Energy Saver, First Boot and Program Speed.
Use the same procedure as Machine Type to set the Model Type, Energy Saver, First Boot and Program Speed.
2.6.3 Touch Console – Default Tab
The Default Tab displays the default information of the console, such as Workout Time, Weight, Age etc... Selecting the
data that needs to be set will bring up a slider to adjust the corresponding information. Refer to the figure below:
CHAPTER 2: ENGINEERING MODE
will automatically bring up the corresponding select block, use the frame
automatically bring up
the corresponding
select block
Touching here will bring up a slider
Restore to the factory settings
Touch this
arrow to
adjust the
information
19