POWER UP – LOCAL, EXTERNAL TRIGGER – LOCAL, CIRCUIT BREAKER SWITCH – OFF PLEASE REFER TO: ‘BRYSTON’S SAFETY MANUAL’ FOR FURTHER OPERATING INSTRUCTIONS. Tampering by anyone other than factory author- ized personnel voids the warranty. Warranty service may be obtained by returning the unit to any authorized Bryston dealer or distributor.
Page 3
‘INPUT’ slide switch. In the ‘BAL REG’ position 2 Volts in = 100 Watts at 8 ohms output. This is the recommended setting when using Bryston preamplifiers or any pre- Balanced Vs Unbalanced: Balanced cable interconnects should be used...
Page 4
It should be remembered that the Bryston ST series are powerful amplifiers, and that it is pos- sible to damage almost any speaker if an ampli- Bryston 14B ST Back Panel: fier is used in a thoughtless or abusive manner.
Page 5
BRYSTON 14B ST MANUAL SPECIAL INSTRUCTIONS FEATURES AND SPECIFICATIONS: Maximum continuous output power with both channels driven can only be realized on a 120 Volt 20 Amp or 230 Volt 10 Amp version of the 14B ST Music is a “Dynamic and Transient” condi-...
Page 6
Bryston. In the event of a defect or malfunction, Bryston will remedy the problem by repair or replacement, as we deem necessary, to restore the product to full performance.