Advertisement
3-CHANNEL WIRING
The amplifier inputs are white cables. Each cable is marked with a numbered band at the end of the
cable.
1. Refer to Figure 9 for the following connections:
Connect CH 1 signal (left) to white input cable 1.
Connect CH2 signal (right) to white input cable 2.
Connect CH3 signal (Subwoofer) to white input cable 5.
NOTE: White input cables 2 and 4 are not used. To avoid accidental shorting of these cables to the
chassis, and to reduce noise, use a wire nut to connect the "hot lead" and shield in each cable.
2. Set the amplifier switch to 3 CH as in Figure 10 . This provides the following output powers:
CH1: 100 W at 8 ohms
CH2: 100 W at 8 ohms
CH3: 100 W at 8 ohms
(These are minimum recommend loads.)
3. Refer to Figure 9 . Connect the speakers as follows. Route the CMA-1 colored output cables
separate from its white input cables to prevent oscillations. Using crimp terminals, connect the
CMA-1 colored cables to the speaker terminals, taking care to observe the cables colors and
polarities noted below:
Blk/Wht:
CH 1 +
Wht/Red:
CH 2 +
Red/Wht:
CH 2 +
Grn/Yel:
CH 2 +
Blu/Red:
CH 3+
Yel/Red:
CH 3 -
NOTE: The Back, White, Red and Green cables are not used. To avoid accidental shorting of these
cables, clip exposed ends back to the insulation, and cover with electrical tape.
Left Speaker
Right Speaker
Subwoofer
13
Advertisement
