Vehicle Operation; Option Programming - CrimeStopper RS-800.IV Installation Instructions Manual

The RS-800 IV system can be used for 2-car operation. A single RS800 IV remote
control can operate two independent vehicles with RS800 IV systems installed.
SETUP:
1. Using the switch on the side of the remote set your controller to Car II.
2. At Car II: Simply follow the transmitter programming steps listed in the
section above. Learn YOUR remote, along with Car 2's existing remotes.
This system has several installer programmable features as listed in the chart below.

Option Programming:

1. Open hood (Ground the Gray wire if no hood pin is installed).
2. Turn Key to the ON position
3. Press program button 5 times, after a few seconds the unit will flash the lights 5 times.
4. Push the valet/program button [again] the number of times that corresponds to the option number desired. You
should get a light flash after each button press. If the unit did not flash the lights, then it did not register your
press.
5. When you reach the desired programming level, either Tap the Brake Pedal or Press the Start Button to change
the selected option. See the chart on next page for option values and descriptions.
6. Turn Ignition OFF, Close hood and check for changed features.

2-VEHICLE OPERATION

OPTION PROGRAMMING
9