What You Need; The 3D Glasses - Philips 65PUT8609 User Manual

12
3D
12.1

What you need

This is an Active 3D TV. On this TV, you can watch 3D
programmes and movies in full High Definition resolution with
Active 3D.
To watch 3D you need to :
• Tune to a TV channel that broadcasts programmes in 3D.
• Rent a movie in 3D from an online video store with Smart TV.
• Watch a movie in 3D from a 3D Blu-ray Disc, a USB device or
computer.
You can view photos in Ultra HD resolution in 3D, from a USB
connection.
Also, to watch 3D on this TV, you will need one of these types
of Philips Active 3D glasses. . .
• PTA507
• PTA508
• PTA509
• PTA517
• PTA518
• PTA519
12.2

The 3D glasses

Overview
1 - On or off switch
2 - Player 1 or player 2 selection
3 - Receiver lens
4 - Battery compartment
When you unpack the 3D glasses, also remove the small plastic
foil from the battery compartment that prevents the battery
from running empty.
Switch on and off
Switch on
When a 3D programme is shown on screen, press  on the 3D
glasses and put them on. The glasses need some seconds to
adjust to the 3D signal from the 3D transmitter on the TV. At
first use, this may take up to 15 seconds.
Battery level
You can check the battery level when you switch on the 3D
glasses.
• If the LED light blinks green, you can use the glasses for 4
hours or more.
• If the LED light blinks orange, you can use the glasses for at
least 2 hours but less than 4.
• If the LED light blinks red, the battery is almost empty and less
than 2 hours of 3D watching remain.
Switch off
To switch off the 3D glasses, press . The LED light blinks red 4
times. When the 3D glasses do not receive 3D signals for 2
minutes, the glasses switch off automatically.
3D transmitter
Make sure the receiver lens in the centre of the glasses can
receive the 3D signals. Also, clear objects away from the 3D
transmitter on the TV.
1 - 3D transmitter on the TV
2 - 3D receiver on the 3D glasses
Two-player gaming
You can use these glasses to play two-player games. Two players
can watch the same TV but see two different screens to play a
game.
To switch the glasses to watch the Player 1 or Player 2 screen,
switch on the glasses and then press the Player 1/2 key.
• If the LED light is orange and lits continuously for 2 seconds,
the glasses are set for player 1.
• If the LED light is orange and blinks, the glasses are set for
player 2.
For more information, press
player gaming.
Replacing the batteries
To replace the battery of the 3D glasses PTA508, unscrew the
small battery lid and replace the battery: type CR2032 (3V).
Make sure the + side of the battery is visible. Replace the lid and
fix it with the screw.
To replace the battery of the 3D glasses PTA509, PTA519,
press the small knob on the battery lid and slide the lid up to
open. Replace the battery: type CR2032 (3V). Make sure the +
side of the battery is visible. Replace the lid and slide it down
until it clicks.
 Warning
Danger of explosion if the battery is incorrectly replaced.
Replace only with the same or equivalent type.
Danger
• Do not ingest the battery. Chemical burn hazard.
38
 Keywords and look up Two-