Honda CRF50F 2007 Owner's Manual page 103

Wheels
RIGHT REAR
(10)
(8) lug
(9) slot
(10) brake panel
94
Servicing Your Honda
Installation
1. Reverse the removal procedure. Make sure
the lug ( ) on the swingarm is located in the
slot ( ) in the brake panel ( ). Check that
the chain adjusters are installed properly.
2. Adjust the drive chain (page
3. Torque the axle nut to:
35 lbf·ft (46 N·m , 4.8 kgf·m)
(8)
4. Adjust the rear brake (page
5. Apply the rear brake, release it, then spin the
wheel and check that it rotates freely. Repeat
this procedure several times.
(9)
If a torque wrench was not used to install the
wheel, see your Honda dealer as soon as
possible to verify proper assembly. Improper
assembly may lead to loss of braking capacity.
8
9 10
102 ).
87 ).